NE_011. PSR_HANGER_S-A-1.0

 
 

 BOM

  1. NE_010. PSR_BEAD_S-A-1.0 x 1

  2. NE_011. PSR_HANGER_S-A-1.0 x 2

  3. McMASTER-CARR 91290A017 / M2 x 10 screws x 2

  4. McMASTER-CARR 93738A262 / M2 threaded insert x 2

REQUIRED TOOLS

  1. SOLDERING IRON

  2. M1.5 HEX KEY OR DRIVER

  3. RAZOR KNIFE

ASSEMBLY

CAUTION: soldering irons, molten plastic, and the associated fumes are potentially hazardous. Use best safety practices (e.g. good ventilation, respirator, etc.)

  1. Using a soldering iron, place threaded insert in backside hole of NE_011. PSR_HANGER_S-A-1.0, apply light pressure allowing the plastic to melt and reflow around threaded insert until it is flush with surface.

  2. Run M2 screw through the threaded insert after the assembly has cooled to clear any excess plastic from the hole. Use a razor knife to trim away any excess plastic you see.

  3. Using a soldering iron with a conical tip, tack weld NE_011. PSR_HANGER_S-A-1.0 to NE_010. PSR_BEAD_S-A-1.0 by placing the hot point of the soldering iron where the two parts meet. 3-4 weld points are generally sufficient for light torque. For a stronger joint weld the plastic along the perimeter of the bead.

  4. Repeat step 3 for the other side of the assembly. Use NE_012. PSR_HANGER_BAR_S-A-1.0 to keep everything aligned.